***20x50TS Clear Sanding Sealer Bondtec***

Simtec Clear Sanding Sealer is an easy sanding clear polyester. It is made to make the building of a clear or colored surface easier and sanding that surface much easier.

APPLICATION:

This product can be applied to any wood surface, graphite or fiberglass surface. It will seal the surface completely and build the surface so it is ready to topcoat.

SURFACE PREPARATION:

Prepare the surface to be coated by sanding with 320 grit, non-sterated sandpaper. Then remove all dust of foreign matter from the surface. Special attention should be given to surface preparation as the service life of any coating is prolonged in proportion to the efficiency with which this operation is performed.

PREPARING THE COATING:

Now prepare the clear sanding sealer by adding the correct amount of catalyst, 2% or .5 oz per quart.

Be sure to mix catalyst thoroughly. 20x50TS requires no thinning and your pot life is 20 minutes at 77 degrees F.

Simtec’s 20x50TS can be applied with an HVLP or Lacquer type gun whichever is acceptable in your area. Use 25-45 lbs. air pressure with the lacquer type gun, holding the spray gun 12-18 inches from the surface being coated. You can spray 3 coats 3-4 mills each. Approximately 20 minutes apart or until the previous coat is stringy when you touch it.

You can spray the sealer over itself the next day without sanding between coats. You will actually get a chemical bond between coats.

Now you’re ready for topcoat or your color coat. Just sand the sealer smooth to get a mechanical bond and your ready. You can topcoat with Simtec’s 2700, 2100 or 1900 Clear Topcoats or House of color coat or any other product you may desire.

Simtec Coatings ~ 2088 2^nd Street, Norco, CA 92860

915-279-7010-Direct / 951-279-7011-Fax#